Faucets
Kitchen and bathroom taps: scale-clogged aerators cleaned or replaced, worn cartridges swapped, drips traced to the seat or the cartridge. A tap that drips after a cartridge change usually has a worn seat, and we say so.
A fixture is where hard water shows up first — scale in the aerator, a cartridge that no longer turns smoothly, a toilet that will not stop running. Lake Travis Plumbing handles fixture installation in Spicewood — repairing and installing faucets, toilets, showers, tubs and sinks in Spicewood homes. Call (254) 822-6941, Monday to Friday, 9 AM to 5 PM.

Spicewood water is hard, and fixtures feel it before anything else in the house. Aerators clog with scale until the tap is a trickle. Cartridges wear until the handle is stiff or the tap drips. Toilet fill valves stick and flappers wear until the toilet runs all night. None of these is a big job on its own — but each one wastes water and wears patience, and a running toilet can waste a surprising amount of it.
We repair a fixture where repair makes sense, and replace it where it does not. A tap that needs a new cartridge keeps its tap. A toilet that has had three fill valves and still runs is usually better replaced. If you are choosing new fixtures for a lake house, pick ones with parts that are easy to find and clean — scale is a fact of life here, and a fixture that cannot be serviced is a fixture that will be replaced early. Our guide to fixing a dripping faucet covers the simple case.
One page, one visit pattern: find the cause, fix the part, test the fixture. The four fixture types below cover the work; the fifth item is what every install gets.
Kitchen and bathroom taps: scale-clogged aerators cleaned or replaced, worn cartridges swapped, drips traced to the seat or the cartridge. A tap that drips after a cartridge change usually has a worn seat, and we say so.
Running toilets, weak flushes, fill valves that stick and flappers that no longer seal. The cause is found first — a running toilet is usually a small part, not a new toilet.
Shower valves that will not hold temperature, diverters that stick, tub spouts that leak behind the wall. Replacements are fitted with access kept in mind, so the next repair is not a wall opening.
Bathroom and kitchen sinks: drains that run slowly, traps that leak, supply lines that weep. A sink swap includes new supply lines and a trap that is checked for leaks before we leave. The same applies outdoors: an outdoor kitchen sink and ice maker get the same fitting discipline — see our outdoor and lakefront plumbing in Spicewood.
New supply lines where the old ones are worn, shut-off valves that actually shut off, and a test of every joint before we leave. A fixture that is not tested is not finished.
Call (254) 822-6941, Monday to Friday, 9 AM to 5 PM. Tell us which fixture, what it is doing, and whether you already have a replacement or want us to supply one.
A dripping tap, a running toilet and a slow sink each have a usual cause. We check the aerator, the cartridge, the flapper and the trap before deciding whether to repair or replace.
Repair where repair makes sense — a cartridge, a flapper, a fill valve. Replace where the fixture itself is worn out or parts are no longer available.
The fixture is fitted with new supply lines where the old ones are worn, and shut-off valves that work. Connections are made up and checked as they go.
Every joint is checked for leaks, the fixture is run through its full range, and the area is left tidy.
Call (254) 822-6941, Monday to Friday, 9 AM to 5 PM. Tell us which fixture, what it is doing, and whether you already have a replacement or want us to supply one.
Reaches the nuts under a sink where a normal wrench will not fit.
Removes a worn cartridge without damaging the valve body it sits in.
New braided supply lines and quarter-turn shut-off valves, fitted where the old ones are worn.
Fresh seals on every toilet install, so the base does not rock or weep.
Seals a sink or a tub spout so water stays where it belongs.
Every joint is run and checked before we leave, and the shut-offs are tested so they work next time.
These are illustrative examples of the kinds of jobs this service covers, not records of specific completed jobs.

A bathroom sink with a slow drain and a trap that weeps at the joint has been patched twice. The vanity is sound, but the sink and its fittings are not.
What typically happens: a new sink is fitted on the existing vanity with new supply lines and a fresh trap, and every joint is checked before the visit ends.
Book this service →
A new bathroom needs a freestanding tub fitted with its floor-mounted filler, and the supply lines run through the slab have to be right the first time.
What typically happens: the tub is set, the filler connected, and the whole run pressure-tested before the floor is finished around it.
Book this service →
A kitchen tap can have a cartridge so scaled up that the handle barely turns, and the aerator a trickle. The tap itself is past repair.
What typically happens: a new tap is fitted with fresh supply lines and a working shut-off, and the old cartridge is disposed of.
Book this service →Most fixture problems are small jobs with a clear cause. If the same fixture keeps failing, the cause is usually upstream of the fixture itself.
Ask a pro →Scale in the aerator or a worn cartridge. The aerator is cleaned or replaced, the cartridge swapped, and the tap tested.
Usually a worn flapper or a sticking fill valve. The cause is found first — it is most often a small part, not a new toilet.
A worn mixing valve or a scaled cartridge. Replaced with access kept in mind, so the next repair is simpler.
Scale and soap in the trap and the branch line. Cleared, and the trap checked for leaks at the same time.
Our Google profile shows a 4.9-star rating from 16 reviews. We publish no review text on this page — the full reviews are on our Google profile, where they were written.
Repair it if the problem is a cartridge, an aerator or a seat — those are parts, not a fixture. Replace it if the body is cracked, the finish is gone, or parts are no longer available for that model.
Usually a flapper that no longer seals or a fill valve that sticks. Both are small parts. If the toilet has had several of each and still runs, the toilet itself may be the problem.
Yes — scale builds up in aerators and cartridges, and it wears moving parts faster. Cleaning the aerator now and then helps, and fixtures with parts that are easy to find last longer here.
Yes — tell us what it is when you call, so we can check what fittings it needs. We fit it with new supply lines where the old ones are worn, and test every joint before we leave.
A dripping tap or a running toilet is usually a small part, not a big job. Call Lake Travis Plumbing, Monday to Friday, 9 AM to 5 PM, on (254) 822-6941.
Call Now (254) 822-6941 →Call (254) 822-6941 for Fixture Installation in Spicewood, Texas, Monday to Friday, 9 AM to 5 PM. Describe what you are seeing and we will explain the next step. If you would rather write it down first, use the form and we will call you back during open hours.