Repair Tips

How to fix a dripping faucet in five minutes

A dripping faucet wastes water every hour and wears out its own parts while it does it. Here is how to fix a dripping faucet in five minutes — the quick fix most Spicewood homeowners can do themselves.

A dripping faucet is almost always a worn washer or a worn cartridge — a small rubber or ceramic part that no longer seals. The repair is a five-minute job once you know which type of faucet you have, and it needs little more than a screwdriver and an adjustable wrench.

Key takeaways

  • Shut the water off first, then work out which type of faucet you have.
  • Most drips are a worn washer or a worn cartridge — a small part that no longer seals.
  • If the drip keeps coming back after the part swap, call a plumber.

First: shut off the water and find your faucet type

Turn off the water at the shut-off valves under the sink — one for hot, one for cold. Turn the faucet on to drain the remaining water, then plug the drain so no small part disappears down it. Then work out which type you have: a compression faucet has separate hot and cold handles that turn several times; a ball, cartridge, or ceramic-disc faucet has a single lever. The fix differs by type, and using the wrong part is the most common mistake.

If the shut-off valves under the sink will not turn, do not force them — a seized valve can snap. Use the main shut-off instead; our guide to shutting off your water main in an emergency shows where to find it in a Spicewood slab home.

Compression faucets: replace the washer

  1. Remove the handle screw, usually hidden under a decorative cap, and lift the handle off.
  2. Unscrew the packing nut with an adjustable wrench and lift out the stem.
  3. At the bottom of the stem is a small rubber washer held by a screw. Remove it and take it to the hardware store to match the size exactly.
  4. Fit the new washer, reassemble, and turn the water back on slowly.

In Spicewood, hard water is the reason the washer failed in the first place: mineral deposits roughen the valve seat, and the washer wears against it. Wipe the valve seat clean before fitting the new washer, and check the seat itself for pitting — a pitted seat will chew through a new washer in weeks, and the seat needs replacing too.

Cartridge and ceramic-disc faucets: replace the cartridge

For a single-lever faucet, remove the handle, unscrew the retaining nut, and pull the cartridge straight out. Take the old cartridge to the store — cartridges are not interchangeable between models, and the wrong one will not seal. Fit the new cartridge in the same orientation, reassemble, and test. If the drip stops, you are done. If it does not, the valve body itself may be worn, and the faucet needs replacing rather than another part.

Where the drip is tells you what is wrong

  • Drip from the spout. The washer or cartridge is worn. Follow the steps above.
  • Drip from under the handle. The packing nut is loose or the O-ring under it is worn. Tighten the nut a quarter turn; if it still leaks, replace the O-ring.
  • Drip from the base of the spout. The spout O-rings are worn. Lift the spout off, replace the rings, and lubricate them with plumber's grease before refitting.
  • Drip only when the faucet is on. The aerator may be clogged with scale — unscrew it, clean the screen, and soak it in vinegar to dissolve the mineral build-up.

When to call a professional to fix a dripping faucet

Call if the shut-off valves will not turn, if the valve seat is badly pitted, if the faucet is corroded into place, or if the drip returns after a new washer or cartridge. If water from the drip has been reaching the cabinet or the floor, our leak detection and repair in Spicewood, Texas team can check for damage underneath. A faucet that has been dripping for months may also have damaged the sink or counter underneath, and that is worth a look before the new part goes in.

We are Lake Travis Plumbing. We repair and replace faucets. Ask for the price in writing before work starts. For the rest of the kitchen and bathroom, see fixture installation in Spicewood, Texas and garbage disposal repair and installation in Spicewood, Texas. Call (254) 822-6941, Monday to Friday, 9 AM to 5 PM.

Frequently Asked Questions

How do I fix a dripping faucet in five minutes?

Shut off the water under the sink, remove the handle, and replace the worn washer on a compression faucet or the cartridge on a single-lever faucet. Match the old part exactly at the store.

Why does my faucet keep dripping after I replaced the washer?

The valve seat is probably pitted by hard-water mineral deposits. A pitted seat wears through a new washer quickly, so the seat needs cleaning or replacing too.

What causes a faucet to drip in Spicewood?

Hard well water leaves mineral deposits on washers, cartridges, and valve seats, so the sealing surfaces wear out faster here. Regular aerator cleaning and softening help.

Can I fix a dripping faucet myself?

Most homeowners can, if the shut-off valves work and the faucet is not corroded into place. Call a plumber if the valves will not turn, the seat is pitted, or the drip returns after a new part.

How do I stop a faucet dripping from the handle?

Tighten the packing nut a quarter turn. If it still leaks, the O-ring under the nut is worn and needs replacing.

Get help with plumbing in Spicewood

If your faucet keeps dripping, we will fix it. Ask for the price in writing before work starts. Call Lake Travis Plumbing at (254) 822-6941 and we will take it from there.

Common questions

Good questions

Shut off the water under the sink, remove the handle, and replace the worn washer on a compression faucet or the cartridge on a single-lever faucet. Match the old part exactly at the store.

The valve seat is probably pitted by hard-water mineral deposits. A pitted seat wears through a new washer quickly, so the seat needs cleaning or replacing too.

Hard well water leaves mineral deposits on washers, cartridges, and valve seats, so the sealing surfaces wear out faster here. Regular aerator cleaning and softening help.

Most homeowners can, if the shut-off valves work and the faucet is not corroded into place. Call a plumber if the valves will not turn, the seat is pitted, or the drip returns after a new part.

Tighten the packing nut a quarter turn. If it still leaks, the O-ring under the nut is worn and needs replacing.

Share this guide: X · Facebook · LinkedIn

Ready when you are

A dripping faucet, fixed properly the first time.

Lake Travis Plumbing repairs and replaces faucets. Ask for the price in writing before work starts. Call us and we will take it from there.

Call (254) 822-6941 →
↗
Emergency plumbingCall now